When the air duct conveys general gas, the black steel plate air duct shall be derusted and painted with antirust paint. The dusty gas can be sprayed with anti-wear protective layer. When the ambient air humidity is high, the outer wall of the air duct shall be treated with anti-corrosion and antirust. The inner wall of galvanized steel plate air duct conveying high temperature and high humidity gas should be sprayed with phosphating primer or other corrosion-resistant coatings. When conveying high-temperature gas or low-temperature air in the air duct, the outer wall of the air duct shall be insulated (cold). The purpose of thermal insulation of the air duct conveying high-temperature gas is to prevent the heat loss of the air in the duct (which occurs in the central air conditioning system in winter); In addition, it can prevent the heat from being radiated into the room to raise the room temperature when transporting waste heat steam or high-temperature gas, and prevent people from being scalded by contacting the air duct.

山東通風麻豆视频官网加工

Shandong ventilation pipe processing Co., Ltd

完善濟南通風麻豆视频官网加工工藝，不同的產品在加工工藝上不同，質量上也是完全不同的，真正的完善產品的加工工藝，這樣對麻豆精品国产传媒來說是有很大的好處。隻有你在整體的加工工藝上不斷的提升，質量上就能夠有更好的保障，這個方麵對麻豆精品国产传媒今後更好的使用產品來說是有大的保障的。你對這一點要真正的注意到，畢竟其真正的關係到麻豆精品国产传媒今後的使用情況。

Improve the processing technology of ventilation pipes in Jinan. Different products are different in processing technology and completely different in quality. It is of great benefit to us to really improve the processing technology of products. Only if you continuously improve the overall processing technology can you have a better guarantee in terms of quality, which is a great guarantee for our better use of products in the future. You should really pay attention to this. After all, it is really related to our future use.

淨化風管的質量直接關係到係統是否達到設計參數和正常使用要求，其製作一般采用工廠集中製作和現場製作兩種方式。無論采用哪種製作方式，都要保證製作場地的潔淨和封閉，選用水泥地麵或地麵鋪設金屬鋼板，其麵積不得小於100m²，且滿足采光和照明條件，製作完成的淨化風管要進行堆放，並進行看管;如果選用現場預製時，要保證預製完成後的風管能夠及時運施工現場，盡量減少風管搬運的距離，這樣可以避免運輸過程中對風管的汙染。

The quality of purified air duct is directly related to whether the system meets the design parameters and normal use requirements. It is generally made in two ways: Factory centralized production and on-site production. No matter which manufacturing method is adopted, the manufacturing site shall be clean and closed. Cement ground or metal steel plate shall be laid on the ground, and its area shall not be less than 100m ²， And meet the daylighting and lighting conditions. The fabricated purified air duct shall be stacked and watched; If on-site prefabrication is selected, ensure that the prefabricated air duct can be transported to the construction site in time, and minimize the handling distance of the air duct, so as to avoid pollution to the air duct during transportation.